- 您现在的位置：买卖IC网 > Sheet目录480 > MTD6P10E (ON Semiconductor)MOSFET P-CH 100V 6A DPAK
MTD6P10E
12
90
1000
10
8
6
4
Q 1
Q T
Q 2
V GS
I D = 6 A
T J = 25 ° C
75
60
45
30
100
10
V DD = 50 V
I D = 6 A
V GS = 10 V
T J = 25 ° C
t r
t d(off)
t d(on)
t f
2
15
0
0
2
Q 3
4
6
8
10
V DS
12
14
0
16
1
1
10
100
Q T , TOTAL CHARGE (nC)
Figure 8. Gate ? To ? Source and Drain ? To ? Source
Voltage versus Total Charge
R G , GATE RESISTANCE (OHMS)
Figure 9. Resistive Switching Time
Variation versus Gate Resistance
DRAIN ? TO ? SOURCE DIODE CHARACTERISTICS
6
5
4
3
2
1
V GS = 0 V
T J = 25 ° C
0
0.50
0.75 1.0 1.25 1.50 1.75
2.0
V SD , SOURCE?TO?DRAIN VOLTAGE (VOLTS)
Figure 10. Diode Forward Voltage versus Current
SAFE OPERATING AREA
The Forward Biased Safe Operating Area curves define the
maximum simultaneous drain ? to ? source voltage and drain
current that a transistor can handle safely when it is forward
biased. Curves are based upon maximum peak junction
temperature and a case temperature (T C ) of 25 ° C. Peak
repetitive pulsed power limits are determined by using the
thermal response data in conjunction with the procedures
discussed in AN569, “Transient Thermal Resistance ? General
Data and Its Use.”
Switching between the off ? state and the on ? state may
traverse any load line provided neither rated peak current
(I DM ) nor rated voltage (V DSS ) is exceeded and the
transition time (t r ,t f ) do not exceed 10 m s. In addition the total
power averaged over a complete switching cycle must not
exceed (T J(MAX) ? T C )/(R q JC ).
A Power MOSFET designated E ? FET can be safely used
reliable operation, the stored energy from circuit inductance
dissipated in the transistor while in avalanche must be less
than the rated limit and adjusted for operating conditions
differing from those specified. Although industry practice is
to rate in terms of energy, avalanche energy capability is not
a constant. The energy rating decreases non ? linearly with an
increase of peak current in avalanche and peak junction
temperature.
Although many E ? FETs can withstand the stress of
drain ? to ? source avalanche at currents up to rated pulsed
current (I DM ), the energy rating is specified at rated
continuous current (I D ), in accordance with industry
custom. The energy rating must be derated for temperature
as shown in the accompanying graph (Figure 12). Maximum
energy at currents below rated continuous I D can safely be
assumed to equal the values indicated.
in switching circuits with unclamped inductive loads. For
http://onsemi.com
5
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MTD8000N4-T
PHOTOTRANS 880NM DOME CLR TO-18
MTD8600N-T
PHOTOTRANS 880NM DOME CLR TO-18
MTD8600N4-T
PHOTOTRANS 880NM DOME CLR TO-18
MTD8600T-T
PHOTOTRANS 880NM FLAT CLR TO-18
MTD8600T4-T
PHOTOTRANS 880NM FLAT CLR TO-18
MTE1081C
INFRARED EMITTER 3MM 810NM
MTE2087NJ2
EMITTER IR 870NM DOME CLR TO-46
MTE2087NN
EMITTER IR 870NM DOME CLR TO-46
相关代理商/技术参数
MTD6P10ET4
制造商:ON Semiconductor 功能描述:Trans MOSFET P-CH 100V 6A 3-Pin(2+Tab) DPAK T/R
MTD7030
制造商:MARKTECH 制造商全称:Marktech Corporate 功能描述:PHOTO DIODE
MTD7030A
制造商:MARKTECH 制造商全称:Marktech Corporate 功能描述:PHOTO DIODE
MTD8000M3B-T
制造商:Marktech Optoelectronics 功能描述:PHOTOTRANS 880NM DOME 3MM
MTD8000M3B-T-DIG
制造商:Marktech Optoelectronics 功能描述:PHOTOTRANS 880NM DOME 3MM
MTD8000N
制造商:MARKTECH 制造商全称:Marktech Corporate 功能描述:Metal Can Photo Transistor
MTD8000N_2
制造商:MARKTECH 制造商全称:Marktech Corporate 功能描述:Optical Switches, Edge Sensing
MTD8000N4T
制造商:MARKTECH 制造商全称:Marktech Corporate 功能描述:Peak Sensitivity Wavelength: 880nm